Видео

what the actual fuck

If the eeprom read in this way is poured into the donor, will it turn out to be a clone?

Dang that's faster than glk

was this add a key, or all keys lost?

What type of wrench / setup is used to remove the torx screw? Also how far in the dash ? Behind the hump on right side of dash ? Just can’t find it . Any help or advice is appreciated

Hi sir what software is this. Thank you

Hii guys, one question. Can I use EIS and a key from facelifted model and program them into the car computer? Mine is w211 from 2003. pre-facelift. The only reason for eis "upgrade" is the ability to add keyless go, push button start and remote startup with your phone and an app.

Did I miss something????!!!🤦🏽‍♀️

Thanks for not showing how to unplug the big connector.

Today we wanted to remove the Immobilizer from my Mercedes 300 SEL (W140) from 1993. We couldnt find it behind the speedometer, where else it can be??

How did you get the PIN code

Would have been better with a commentary and no stupid music.

Thanks alot!

Thank you bro! You are a true legend!

Can this be done in uk ?

What is the point of this video? To show that you can do it but not to instruct others??

Why you have bee struggle

Can somebody help me with my car

1997 cl600

I removed the cluster with the battery still connected got out the Eis and programmed new keys no problem but when I reconnected the cluster it’s dead if any one could help me correct this situation it would be greatly appreciated

useless

I need some help with my immobilizer system for SL 500 94 $

Worst video🤣

What about all keys lost. Put non coded key in ignition and then tried to turn on. Nothing. Put original back in ignition and straight away it would not turn. Ignition locked. Any ideas…?

How much does it cost to reprogram the key bob

Hey have a question my ignition gave out steering is locked. If I get one of eBay with key does it need to be program or once installed I’m good to go? Pls lmk Thx in advance

can I do it if the only key that I have has no buttons?

Why isn't that module bolted in?

very very poor video cant entirely see what he's doing

Your video save me a Bunch of time on an 08 R350....thnx for posting!

perfect, just what i was looking for.

With Abrites I did a Cayenne 2006 without having to desolder the eeprom and read it. I actually did read the eeprom and got the code from the dump tool in Abrites but later when I followed the instructions in Abrites on how to program keys I discovered that under special tools, read ECU and then read flash (not read Eeprom as per instructions) the code for the Kessy came up, same code as I got from the dump file from the Kessy Eeprom. I will make a video and post, it might not work for newer Cayennes but for the older it does.

Alex it's tj from roxborough pa....I hate to do this on RUclips...but I have bad news..my mom has past away ...

nice and quick well done mate.

برو تيتو

To all of you Once you remove the bracket you have to move the air conditioner duct out of the way t

Porsche cayenne 2007. Can I do a spare key via old port or do I have to do it EEPROM

Only this guy knows what he is doing!

2016 boxster718 Same location? Thanks

I can’t believe what you just did . Waist my got damn time pull it down

I seen where you can loosen the switch bolt and remove the radio and pull it out with less work!

The T300's available do not show SAAB as a covered vehicle in the list on any website. Are you using an original tool? Being that it has the passord 1234...on the cover of the tool, it looks like clone of some sort, so is it just not listed on the sites and it has the carline anyway or is this how the original tool is? Thanks very much

You doing too fast on this video even not show how to disconnect the kessy. Please make little slower next time please? Thank you.

Hello, I like to thank you for this video helps a lot. I have 2013 audi a4 all keys lost, I'm trying add key using maxisys autel 608 and security alarm is on and won't let me programming the key when I try generate pcm it failed. Can you help me how can I fix this problem? Thanks in advance!!

Alex Is one of the best Locksmith I Met him along time ago

BCM is Brak Control Module. This is the ECM. Which is the Electrical Control Module.

Payless what you just shown was one of the most insanely idiotic thing I have ever watched. At no point in your rambling, incoherent video were you close to anything that could be considered a rational video. Everyone who has seen this is now dumber for having watched it. I award you no likes, and may God have mercy on your soul.

There's other way of doing this. Remove stereo, then cut some plastic between stereo and EIS until EIS can be pushed to the stereo opening. Also not easy, but not too hard with right tools (I removed plastic bit by bit with small vise grips - that's all I had available at the moment).

Why do you remove mirror?

The sound of bit spinning and grinding the screw heads... cringe*